HydroPro™ dissolves quickly and completely in water and is easier to print with than other water soluble materials such as PVA and PVOH.
HydroPro™ is non-toxic and fully biodegradable, meaning it can be rinsed down the drain without harming the environment or wildlife.
Superpower
HydroPro™ only needs to be soaked for 1-2 hours to easily work supports off by hand, or 2-6 hours to dissolve completely.
Best Suited For
Use it as a support material to print large overhangs, intricate inner geometry, and deep cavities.
Bed Material
PEI, Buildtak recommended with a heated buildplate (45-60° C)
Note
Note: Because HydroPro™ breaks down in water, it is sensitive to high levels of humidity in the air. For best results, store unused HydroPro™ filament in a sealed container with desiccant.
Fargo 3D Printing is not associated with HID Global and their FARGO division.
LEGAL DISCLAIMER
THE PRODUCTS SOLD ON THIS WEBSITE SHOULD ONLY BE USED BY EXPERIENCED INDIVIDUALS, OR UNDER THE DIRECT SUPERVISION OF EXPERTS. NO WARRANTY OF THEIR SUITABILITY FOR ANY PURPOSE WHATSOEVER IS MADE OR OFFERED BY US. YOUR USE OF THE PRODUCTS SOLD ON THIS WEBSITE IS ENTIRELY AT YOUR OWN RISK. YOUR PURCHASE OR USE OF ANY PRODUCT HEREFROM SHALL SERVE AS YOUR EXPLICIT ACKNOWLEDGEMENT THAT YOU UNDERSTAND AND CONSENT TO THE FACT THAT WE HEREBY DISCLAIM ANY RESPONSIBILITY OR LIABILITY FOR, ANY HARM, LOSS (ECONOMIC OR OTHERWISE), INJURY OR DEATH RESULTING FROM THE ASSEMBLY OR OPERATION OF OUR PRODUCTS, EITHER AS INSTRUCTED OR OTHERWISE, AND AFFIRM THAT UNDER NO CIRCUMSTANCES SHALL YOU BE ENTITLED TO ANY DAMAGES OF ANY SORT WHATSOEVER RELATED TO YOUR USE OR MISUSE OF OUR PRODUCTS.
Add to CartQuick View
Add to CartQuick View
Add to CartQuick View
