Creality BLTouch Auto Leveling Sensor Kit
Out of stock
Add intelligent auto bed leveling with this complete kit. Everything you need for hardware is included is this package.
The BLTouch standard deviation repetition accuracy is about 0.005mm.
- Compatible with:
- Ender-3 Pro
- Ender 5
- Ender 5 Plus
- CR 10S4
- CR 10S5
- CR-20 Pro
- NOTE: Mounting Bracket is not compatible with: CR-10 V2, CR-10 V3, CR 10S Pro (Will have to print or source your own)
- NOTE: You may need to extend the wire for printers with larger cable runs such as the CR-10s series or Ender 5 Plus
If your motherboard is V1.1.4/V1.1.5, need to use the included ISP Cable to flash firmware.
If your motherboard is V4.2.2/V4.2.7, just use the SD card to flash firmware. (We do recommend the CR-Touch for easier installation on these boards)
For Installation instructions: https://youtu.be/jqxlQkkt8cM
- What’s Included:
- 1x BLTouch
- 1x extension cable (3+2 DuPont connector)
- 1x Zip tie pack
- 1x Bracket
- 1x M3X8mm
- 1x M3X6mm
- 1x ISP connector
- 1x Pinboard A
- 1x Pinboard
- 1x Burner.