- You cannot add "MakerBot Replicator 2 Heater Block" to the cart because the product is out of stock.
Creality BLTouch Auto Leveling Sensor Kit
Add intelligent auto bed leveling with this complete kit. Everything you need for hardware is included is this package.
The BLTouch standard deviation repetition accuracy is about 0.005mm.
- Compatible with:
- Ender-3 Pro
- Ender 5
- Ender 5 Plus
- CR 10S4
- CR 10S5
- CR-20 Pro
- NOTE: Mounting Bracket is not compatible with: CR-10 V2, CR-10 V3, CR 10S Pro (Will have to print or source your own)
- NOTE: You may need to extend the wire for printers with larger cable runs such as the CR-10s series or Ender 5 Plus
If your your motherboard is V1.1.4/V1.1.5, need to use the included ISP Cable to flash firmware.
If your motherboard is V4.2.2/V4.2.7, just use the SD card to flash firmware.
For Installation instructions: https://youtu.be/jqxlQkkt8cM
- What’s Included:
- 1x BLTouch
- 1x extension cable
- 1x Zip tie pack
- 1x Bracket
- 1x M3X8mm
- 1x M3X6mm
- 1x ISP connector
- 1x Pinboard A
- 1x Pinboard
- 1x Burner.